Email: machine@hxjq.com
Company Profile  |     Company Culture    |     Company Honors   |     Service & Parts  |     Production Capacity
HomeCompany NewsSand Crusher Repair and Maintenance Technology
PRODUCT CENTER
E-mail: machine@hxjq.com Tel: +0086-371-67833171

Sand Crusher Repair and Maintenance Technology

Author: HXJQTime: 2/28/2013 5:51:20 PM

 Any equipment needs routine maintenance, in order to extend the useful life of equipment, sand crusher also needs the careful maintenance, and it can work for us for a long time, but do you know the sand crusher maintenance technology? Now I come to tell you about the knowledge. First, it is necessary to schedule downtime to observe the wear of the inside central feeding tube, cone hat, impeller, indecent road liner circumference guard liner, after wear, which should be timely replaced or repaired, replaceable wear block should be replaced at the same time, and ensure the the same weight of wear blocks. Prohibiting observe the inner workings of the case when the crusher is working in order to avoid danger.

sand maker 

     If you find that the impeller is worn, you should replace it or ask manufacturers to timely repair it. Special attention, without the manufacturer's consent, forbidden homemade impeller. Second, a new sand crusher adopts premium grease or 3 # lithium grease, construction results in six hazards per work 400 hours to 2,000 hours, and you should add the right amount of grease, cleaning open bearing spindle assembly, general work 7200 hours, and replace a new bearing. The upper end of the spindle assembly bearings is for swimming in the end, the lower end bearings are fixed end, hand pulled the pulley flexibly.
     Transmission triangle tape taut size should be adjusted appropriately, Hongxing sand crusher new technology ensures the average force triangle tape, on both sides of the triangle tape should be grouped optionally if dual motor drive, then each group of its length is consistent as possible. You should adjust so that the difference between the two motor current does not exceed 15A. When the sand maker is operating, because this device is a high-speed operation of machinery. Therefore, you need to pay particular attention to security. During machine is operating, the relevant operators should be away from the device. If you need to carry out the necessary repair work, you can go on the work when the device stops working. Avoid unnecessary personal accident.